Headliner installed

Hello everyone,
A few more jobs ticked off the list over the last few weeks.  The most obvious is a nice new headliner in the cabin.  The old headliner was the original fitted in 1986, and had seen more than its fair share of tobacco smoke.  The new one is made from Laminex AquaPanel and was fitted by Neil the local shipwright.

New headliner (looking aft)

New headliner (looking forward)

The cabin is much lighter with this addition, and with the lights on it's dazzling.  Just as well we went for the white "glaze" rather than "gloss"!  Another difference is the "bling".  Previously the fasteners were buried behind teak plugs, which was pretty but made the deckhead unreachable.  We've used s/s screws in saddle washers which are easy to remove and add a little "bling".  ;)

Other jobs completed recently include:

• Fitted new Plastimo Contest 101 compass (20 year old unit was 1/5 full of air)
• Replaced galley sink faucets
• Stripped discoloured foam-backed nylon liner in quarterberth (will fair and paint)
• Fitted coachroof U-bolts for use as jackstay anchor points
• Fitted deadeyes on foredeck for jib furler and MPS downhaul lines
• Removed spinnaker pole mounting brackets (we've decided to ditch the pole)

Items still on the to-do list include:

• Fit locking foot blocks in cockpit
• Fit new Lifeline AGM deep-cycle batteries and associated switches/sensors
• Replace broken galley sea-water footpump
• Order new storm jib to fit on inner forestay furler

The weather in Darwin has turned wet over the last week.  We've had two good downpours and a few showers - all from thunderstorms.  They certainly cool things down.  The marina basin now seems to contain more fresh water than salt water since the local run-off passes through the basin en-route to the sea.

Hope all's well where you are!

Three Months in Darwin

We've now been in Darwin for three months.  Time flies!  We've been here so long we've had to get Northern Territory driver licences.

One decision we've made recently is to join the SE Asia cruising events next year.  These depart Darwin in July and we plan to go through Indonesia, Malaysia and Thailand, arriving in December 2012.  After that we'll resume Plan A (South Africa).

Under canvas

We are both working so the cruising kitty is doing well.  Or should I say the to-do list is being attended to!  Since our last blog we have:

• Fitted an all-chain anchor rode
• Fitted a boom tent and foredeck awning from The Canopy Man
• Removed the old cabin headliner, found replacement material (Laminex Aquapanel) and sanded, epoxied and varnished the teak battens which mount the headliner
• Fitted new Spinlock deck organisers, Spinlock clutches and Andersen winches
• Fitted permanent inner forestay with ProFurl furler

Fitting the new deck gear followed removal of the headliner.  With the headliner down all the bolts were easily accessible so the time was right.  It took quite a while to clean and fill all the old bolt holes with epoxy since the end-grain balsa core in the coachroof soaked it up as fast as we could add it! We only discovered the coachroof was a sandwich construction when the headliner was removed.  Should be light and strong.  While we were at it we decided to replace the cockpit winches and turning blocks.  Just as well since several of the bolts securing the turning blocks were rusted through.

Deckhead exposed

New Andersen halyard winch

New Andersen sheet winch

By the way, we sold the old winches on eBay and recovered 1/3 the cost of the new winches.  The old winches were in very good order but the self-tailer wouldn't grip the (smaller) modern ropes we use and servicing required complete removal of the winch from the deck.
Still plenty to do!


The best investment we've made since arriving is the purchase of a $50 second-hand air-conditioner.  Life was much more comfortable after we got that running.  With the "build up" to the wet season well underway the aircon will keep us cool and help keep the boat free of mould.


Another investment which is working out well is the Coppershield anti foul (known as Coppercoat outside Australia) we applied in Sydney early this year.  We're getting very little fouling in the marina, and since Coppershield is non-ablating we can go for a swim and simply wipe off any minor growth.


It's been fun meeting other Western Australian yachts here.  Mike and Jan from Fully Involved passed through recently, having sailed their lovely yacht from the US this season.  Dan and Elise from Babar are also here.  Both are from Hillarys Yacht Club.